Description

This listing is for One AA Mini Maglite Repair Switch Assembly ( 108-000-211 ) and One AA Mini Maglite Replacement Lens ( 108-000-046 ) with Facecap O-Ring ( 108-000-045 ) THOUSANDS SOLD. INSTALLATION ASSISTANCE AVAILABLE. Authentic AA Repair Switch Assembly comes preassembled and requires disassembly of the two main components to install ( Upper and Lower receptacles ). Use caution when separating components. A third vital component, the Side Contact # 13 is installed into the Lower Receptacle between the two main components and can easily be displaced or lost. ( **TIP: Visually locate the Side Contact between the Upper and Lower Receptacles prior to installation!) Pease read instruction prior to attempting installation. Additional instruction included on the reverse side of the factory instructions. Your Authentic AA Mini Maglite Switch Assembly comes with a repair and maintenance instruction sheet Part # 413-000-807*. The Switch Repair Assembly comes pre-assembled and contains 4 components; #15) Lower insulator Receptacle, #10) Upper Insulator Receptacle, #13) Side Contact** and #14) Center Contact. Easy to install with or without the Repair Switch Installation tool (available as item # 172336487398 AA Switch Repair Assembly and Installation Tool Kit). (Additional AA Switch Assemblies available as eBay item #172917149399). Please disregard the "DO NOT REMOVE" imprinted into the top of the Upper Receptacle as it is intended to prevent accidental disassembly during normal maintenance and bulb replacement. *AA Mini Maglite Flashlight Switch Maintenance and Repair Instruction Manual Part # 413-000-807 is also available in French, Spanish, German, Italian and Japanese upon request. First disassemble your flashlight using steps# 1 - # 4 of the factory installation instructions. Skip step # 5 - # 7. **Note: The Side Contact # 13 by design is loosely set into the Lower Receptacle # 15. Caution should be use when preparing to install your switch. Upper and Lower Receptacles must be separated prior to installation and the side contact may be damaged or lost during the separation process unless extreme care is used. Work on a flat, clean surface with good illumination. Holding the assembly upright with the " do not remove "imprint on top, locate the metallic Side Contact # 13 in the groove between the Upper and Lower Receptacles. Gently pry the Upper Receptacle loose avoiding the T-shaped edge of the Side Contact as it can be easily damaged. Do not insert knife or screwdriver between the Upper and Lower Receptacles as the Side Contact is L-shaped and is mounted into the center of the Lower Receptacle. If unable to separate the components by hand use the edge of a small coin to gently pry up a little at a time . Avoid the Tongue of the Side Contact and work your way around the Switch until the Upper receptacle is loose. Contacts are not sold separately. All Repair Switch Assemblies are inspected prior to shipping. *** Should the Side Contact # 13 become accidently dislodged, please refer to step # 7 in the factory instructions. (Note that your switch assembly may become disassembled during shipping simply refer to step # 7.) Continue with step # 8 to complete your installation. The flat end of a pencil or wooden dowel can be use in lieu of the installation tool. Holding the Flashlight Body #12 at a slight upward angle insert your Lower Switch Assembly into the Body until it stops against the Shoulder or lip. Hold the Lower Receptacle with the Side Contact in place firmly against the Shoulder or lip of the Flashlight Body. Step# 9 Reinstall the Upper Receptacle into the Lower Receptacle. Continue with step # 10